www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
20
|
2. Device description
1. 4-prong centre tip
2. Tool support
2a Screw, height adjustment
4. Lock nut
5. Tailstock
6.
7.
8. Lever, tailstock
9. Lever, tool support
10. On switch
11.
12.
13.
14.
15.
16. Open-ended spanner
17. Screws with spring washer and standard washer
18.
washer and nut
19. Drive shaft
20. Locking screw
21. Gearing cover
22. Locking screw
23.
24. Lever, motor unit
25. Drive disc
26. V-belt
27.
3. Scope of delivery
•
•
• Tailstock
• Tool support (two-part)
• 2 wood-turning chisels, (1x straight, 1x hollow)
• 2 x open-ended spanners
•
•
- 6 hexagonal bolts
- 6 spring washers
- 6 washers
- 6 nuts
- 3 screws
- 3 spring washers,
- 3 washers
• Operating manual
1. Introduction
Manufacturer:
scheppach
Dear Customer
and success.
Note:
laws, the manufacturer of this device assumes no
•
•
•
specialists
•
•
•
electrical regulations and VDE provisions 0100,
Note:
purpose.
The operating manual includes important instructions
for the safe, proper and economic operation of the
product, for avoiding danger, for minimising repair
and extending the service life of the device.
-
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture.
-
sonnel before starting the work.
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
-
to the operation of such machines must also be ob-
served.
occur due to a failure to observe this manual and the
To Next Page
Loading...
