www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
24
|
m ATTENTION!
The device and the packaging material are not
children‘s toys! Do not let children play with
plastic bags, lms or small parts! There is a dan-
ger of choking or suocating!
9. Assembly
Assembling the lathe (Fig. 2)
1. Slide the tool support (2) onto the rail with motor
unit (3a).
2. Slide the tailstock (5) to the tool support (2) on
the rail with the motor unit (3a). Check that the
-
3. Connect the rail with the motor unit (3a) and the
rail (3b) without the motor unit together.
4. Screw the two rails together with the three screws
withspring washer and standard washer (17) us-
.
Note:
If it is dicult to move the tool support (2) or the
tailstock (5), adjust the nut on the underside with
a spanner or ratchet (19 mm).
Setting up the lathe (Fig. 1)
1.
2. Screw the lathe to the surface.
in each of the three feet (7) for this.
3. You can use the hexagonal bolts (18) supplied
with the lathe for this.
4. Place the standard washer and spring washer on
the hexagonal bolt (18).
5. Screw the lathe to the surface with the help of the
hexagonal bolt, standard washer, spring washer
and nut (18).
Fitting/replacing the workpiece mount (Fig. 3)
m ATTENTION!
Switch the device o and pull out the mains plug.
Fitting the 4-prong centre tip
1. To do this,
open-ended spanner (16) and unscrew the face
plate (13) from the drive shaft (19).
2.
open-ended spanner (16).
3. Tighten the 4-prong centre tip (1) onto the drive
shaft using the second open-ended spanner (16).
(13) must be used instead of the 4-prong centre tip
(1).
7. Technical data
1375 x 325x 415 mm
Speed
-1
1000 mm
diameter
350 mm
Spindle head thread
20,5 kg
Engine
Subject to technical changes
* Operating mode S2 – short-term operation
Operation at a constant load for 15 minutes or less,
within 2 K of the ambient temperature.
The noise and vibration levels have been determined
in accordance with EN 61029.
Sound pressure level L
pA
71
pA
Sound power level L
84
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration emission values (vector sum of three direc-
tions) determined per EN 61029.
8. Unpacking
• -
vice.
•
•
•
damage.
Later claims will not be
recognised.
•
•
time.
• -
-
•
equipment.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
