www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
17. Troubleshooting
Fault Possible cause Remedy
Cutting tool is brunt. Sharpen or replace cutting tool.
.
The cutting tool is positioned below
the workpiece centreline.
above the centre of the workpiece.
rotation speed
Adjust speed
Excessive vibration
when turning thin
workpieces.
The cutting tool is below the work-
piece centreline.
-
piece.
.
Excessive vibration
when turning large
workpieces or bowls.
-
workpiece.
or tailstock are correct.
The workpiece is not balanced. Cut the end of the part until the workpiece is bal-
anced.
Lathe does not turn. Cable not connected to the mains
socket.
Connect it to the mains socket.
door located inside the motor ac-
cess hatch, is broken or engaged.
Damaged or defective power switch
Do
To Next Page
Loading...
Need help?
General
Weight and Dimensions
