www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
26
|
11. Working instructions
•
detail in technical literature.
•
knotholes, cracks or similar. You could lose con-
Cracked workpieces can rupture during turning.
•
possible before machining.
• Observe the maximum workpiece length and the
maximum workpiece diameter!
in the technical data.
• -
machine.
•
•
•
check the following
-
- Does the workpiece come into contact with the
•
•
reached the set rotational speed.
Remove blockages
Switch the device o and pull out the mains plug.
Clean the device of dust and chippings to remove the
blockage.
12. Electrical connection
for operation. The connection complies with the ap-
The customer‘s
mains connection as well as the extension cable
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
•
wall outlet.
• Cracks due to the insulation ageing.
9.
10.
11. -
ternut (4).
Securing with the face plate (13) (Fig. 4)
1.
open-ended spanner (16).
2.
(19).
3.
m ATTENTION!
Danger of injury! Position the wood screws
such that they will not be accidentally ex-
posed by the tool when machining the work-
piece.
4.
open-ended spanner (16).
5. Screw the face plate (13) with the pre-mounted
workpiece onto the drive shaft (19).
Adjusting the tool support (Fig. 1)
m ATTENTION!
Danger of injury! Make sure that the tool support
is well xed and cannot come loose during op-
eration.
Fixing/releasing the tool support
1.
(9) downwards.
2.
lever (9) upwards. You can now move the tool
support.
Height adjustment of the tool support
3. Loosen the screw (2a) on the lower part of the tool
support (2b).
4. Set the desired height.
5.
(2a).
Switching on/o (g. 1)
1. Connect the device to the mains voltage.
2.
the device on.
3. the
m ATTENTION!
If you leave the device unattended or have n-
ished working, pull out the mains plug.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
