www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
22
|
20 Attention!
– The use of other insertion tools and other ac-
21
electrician
– This electric tool conforms to the applicable
-
parts. Otherwise accidents can occur.
22 Do not use the cable for purposes for which it is
not intended Do not use the cable to pull the plug
out of the outlet. Protect the cable from heat, oil
and sharp edges.
Warning! This electric tool generates an electro-
active or passive medical implants under certain
manufacturer of the medical implant prior to operat-
ing the electric tool.
Operational Safety Instructions for the Wood
Turning Lathe
•
earthed mains socket.
•
and wood-turning techniques before using the ma-
chine.
• Examine all workpieces for splits or knots. Glued
•
position and all attachments are secured.
•
• -
ing workpiece.
•
workpiece, tailstock, or tool rest.
•
• The machine is designed for use with wood-turn-
•
• Do not run the lathe without its covers and guards
in place.
• Keep cutting tools sharp.
• -
piece.
•
lathe is run so fast that it vibrates, there is a risk
that the workpiece will be thrown or the cutting tool
–
tool replacement.
– Check the connection cable of the electric tool
specialist when damaged.
–
them when damaged.
–
grease.
14 Pull the plug out of the outlet
– Never remove loose splinters, chips or jammed
wood pieces from the running saw blade.
– During non-use of the electric tool or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
–
the work piece and ensure that the saw blade
runs free. Turn the machine on and start new
cutting operation with reduced feed force.
15
–
adjusting tools are removed.
16 Avoid inadvertent starting
–
plugging the plug into an outlet.
17
–
extension cables for use outdoors.
–
18
–
sensible when working. Do not use the electric
19 Check the electric tool for potential damage
– Protective devices and other parts must be
free and function as intended prior to continued
use of the electric tool.
– Check whether the moving parts function fault-
-
free operation of the electric tool.
–
in the open position.
– Damaged protective devices and parts must be
-
– Damaged switches must be replaced at a cus-
tomer service workshop.
–
cables.
–
To Next Page
Loading...
Need help?
General
Weight and Dimensions
