www.scheppach.com
22
|
GB
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
-
served.
arise due to non-observance of these instructions and
3. Device description
1. Workpiece support
2. Upper mount, workpiece support
3. Star grip screw
4. Leather honing wheel
5. Machine housing
6.
7. Rubber feet
8. Water tank
9. Washer
10. Grinding shaft
11. Nut
12. Grindstone
13. Fixture for chisel
14. Star grip screw for leather honing wheel
15. Side mount, workpiece support
4. Scope of delivery
1x Wet grinding machine
1x Grindstone
1x Universal holder
1x Angle gauge
1x Honing compound
1x Leather honing disc
1x Operating manual
5. Proper use
m The wet grinding machine is constructed ex-
clusively for use with the tool oered for grinding
steel (no carbide).
• The machine complies with the applicable EC ma-
• The machine is designed for single-shift opera-
tion, duty cycle S1 100%.
2. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
success.
Note:
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
•
technicians,
• Installation and replacement of non-original spare
parts,
•
•
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
-
-
and service life of the machine.
-
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
To Next Page
Loading...
Need help?
General
Weight and Dimensions
