www.scheppach.com
26
|
GB
work with the direction of grinding. This applies, for ex-
ample, to carving tools and knives. Please note that the
direction of rotation.
Please check before each operation whether the sur-
face of the grinding stone is even. To do so, lower the
trimming device.
surfaces.
Water Reservoir (Fig. 4 + 5)
Fill the water reservoir with water up to the marking.
The grinding stone becomes saturated with water. Re-
Once the grinding process is completed, lower the wa-
ter reservoir to prevent the grinding stone from being in
the water for an extended period of time.
-
cles of steel and trimmed stone will accumulate and
compress in the reservoir.
Expert tip:
place a magnet into the water.
Angle Measurer (Fig. 6)
the cutting edge to the notches.-
the universal support. To do so, perform the following
steps:
First, clamp the tool into the device and insert the de-
vice on the universal support.
Then, hold the angle measurer with the desired angle
support in such a manner that the front end of the angle
-
ment with the tool tip.
Note: The values indicated on the angle measurer are
Grinding (Fig. 7)
Expert tip: New tools still show traces of the production
back side in the free-handed mode on the vertical of
the grinding stone, and the front side as follows.
m Warning!
9.2 Sound test
Check the grindstone for cracks and perform a sound
test for crack detection.
• The grindstone must be removed from the machine
for the sound test. The grindstone stands upright on
support.
• -
mer.
sound.
sound.
9.3 Installing the grindstone (Fig. 2)
Technical data).
Assemble grinding stone (12) and the star knob (3) as
9.4 Fitting the workpiece support (1) (Fig. 2 + 3)
Then place the work piece surface (1) into the bracing
element and secure it, using the help of the star knobs
The workpiece support (1) can be attached both to the
upper mount for workpiece support (2) and to the side
mount for workpiece support (15).
against the grinding direction.
9.5 Installing the water tank (Fig. 4 + 5)
The water tank should be hooked into its port (D) (see
10. Working instructions
On/o switch (6) (Fig. 1)
• To switch on the machine, press the green “I” button.
•
Direction of grinding (Fig. 2 + 3)
want to work with or against the direction of grinding.
coarse tools, such as axes, it is recommended to work
against the direction of grinding.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
