Schiller AT-1 - Page 48

Chapter 4
SCHILLER AT-i 3-ChaMel ECG Unit
1
Module Removal and Replacement
SERVICE HANDBOOK Issue 3 September 1999
1
Control and Power Supply Board L'MK 11-1 (cont.)
Board Replacement
To replace the Control and Power Supply board MK 11- 1 proceed as follows:
1. Position the board and secure at the nine fig points ( four on the mauls transformer)
2. COM- the following:
paper mark connector
printer motor connector
live and the neutral bayonet connectors to the mains connector
live and the neutral bayonet connectors to the battery
data connector to the thermal printer
ground connector to the print head
3. Replace the ECG Amplifier (detailed in the previous paragraph) and reassemble the unit
Page 4.12