Schiller AT-1 - Control and Power Supply Board MK 11-1

Chapter 4
Module Removal and Replacement
SCHILLER AT-1 3-Channel ECG Unit
SERMCE HANOBOOK Issue 3 September 1999
Control and Power Supply Board IMK 11-1
TheConuolandPowerSupplyBoardMK!l-1 issecuredtothe base trayandpositionedunderthe
ECG Interface MK 11-2.
Prerequisite
The Warnings and Cmions at the beginning of the Chapter mst be observed
The Top Assembly must be removed and all external cable assemblies disconnected
The ECG Interface must be removed
Tools and Equipment
Pod-drive screwdriver
Parts
Control and Power Supply board MK 11-1. Part number as detailed in Chapter 6.
Board Removal
WARNING
ENSURE THAT THE MAINS CABLE IS DISCONNECTED BEFORE COMMENCING
To remove the Control and Power Supply board MK 11-1 proceed as follows:
1. Disconnect the following connectors:
* paper mark connector
printer motor connector
live and the neutral bayonet connectors
to the mains connector
live
and the neutral bayonet connectors to the battery
data connector to the thennal pnnter
.
ground connector to the pnnt head
note: (the power supplies connector
to the ECG Amulifier will already have been
removed as detailed in the previous paragraph).
2. Unscrew the nine spacer tixauons (four on the mns transromer) and remove the board.
Page 4. I1