17
2. Product description.2. Product description.
2.9 Adjusting the stabilisers
The stabilisers are equipped with
spring elements that can be adjusted
from soft to hard. To do this, loosen
the screw (A) and move the spring
element in the slot. Moving towards the
stabiliser increases the spring hard-
ness. By loosening the two screws (B),
the stabilisers can be adjusted so
that they are o the floor. Tighten the
screws again after all adjustments. In
addition, spring travel can be limited
by means of an adjustable end stop.
To this end, loosen the counter nut (C)
below the support. Spring travel can
now be adjusted by screwing in or out
the screw (D), re-tighten the counter
nut afterwards .
2.10 The initial riding attempts
Please remember that, prior to setting
o on your own, you must first practice
with an accompanying person in order to learn how to deal with riding
around curves on the therapy bicycle, as this is where the risk of acci-
dents is greatest. Always ride around curves as slowly as possible. Please
also keep in mind that the rear is the widest point of the therapy bicycle.
Therefore practise with corresponding obstacles in order to better
estimate the width of the therapy bicycle.
B
C
D
A
To Next Page
Loading...