34
8. Cleaning and servicing.
8.1 Cleaning and disinfecting
8.1.1 Cleaning
To ensure functional safety and the appearance of the bicycle, it must be
regularly cleaned and cared for. Please observe the following guidelines:
• Never allow dirt to dry onto the bicycle, but always remove it with water
and a soft cloth or sponge. Otherwise you may damage the bearings,
the paintwork or the decorations.
• Do not use aggressive cleaning agents. Use a mild detergent
solution to clean.
• Repair paintwork damage immediately.
• The components of the drive system can be cleaned with a soft cloth
moistened with commercially available cleaning products or
soapy water, but not wet.
Please also pay attention to our general cleaning and hygiene advice. This
can be found at www.schuchmann.de/mediathek.
Danger due to rotating parts
The motor can set itself in motion unexpectedly, if the drive system remains
switched on when carrying out cleaning work on the momo therapy bicycle.
with E-drive.
• Remove the E-drive battery before cleaning.
Never use high-pressure cleaning equipment
The use of a steam jet, high-pressure cleaning equipment or a water jet for
cleaning is not permitted. The ingress of water into the control box, motor
or electrical connectors can destroy the equipment.
8.1.2 Disinfection
Various products can be used for surface disinfection of metal and plastic
parts.
Liquid disinfectants are available as ready-to-use solutions that are spray-
ed on and evenly applied with a soft cloth. Alternatively, wipes pre-soaked
with disinfectant can be used to wipe the products over the entire surface.
In both cases, care must be taken to ensure complete wetting. Disinfection
in fully automatic disinfection systems is also possible and recommended.
The exposure times may vary and can be found in the manufacturer's
instructions for the products used.
To Next Page
Loading...