18
3. Settings.
Settings and adjustments to the product or accessories may only be made
by people who have been given the necessary instructions by a medical
product advisor. Please ensure that none of the user's extremities are in
the respective area when making adjustments of any kind to minimise the
risk of injury.
3.1 Presettings
The momo therapy bicycle. is delivered com-
pletely assembled. Prior to initial use, howe-
ver, the following pre-settings must be made.
3.1.1 Handlebar adjustment
You can find our scope of delivery for hand-
lebars on page 7 of these Instructions for use.
Height of handlebars
To adjust the height of the handlebars, remove
the protective cap from the hexagon socket (A),
loosen the hexagon socket (A) and adjust the
stem (B) to the required height. By tapping
the head of the hexagon socket (E) lightly
with a hammer, the stem in the fork steerer
will loosen. Then re-tighten the hexagon so-
cket.
Ensure that the marking for the minimum
insertion depth (C) remains on the stem in the
fork steerer and therefore cannot be seen.
Handlebar adjustment
To adjust the handlebar position, loosen the
clamping screws (D), bring the handlebars into the required position and
then firmly re-tighten the clamping screws (D).
To change the tilt angle on the stem, please loosen the clamping screw (F).
The steerer factory setting is 20°. In this way you can change the distance
between the saddle and the handlebars, and adjust the required handle
height. Then firmly re-tighten the screws again.
After each adjustment, please retighten all screw connections!
After adjustment of the handlebars, there must still be no tension placed on the
brake cables. If necessary, extend the cables!
F
D
A
D
B
E
C
To Next Page
Loading...