Assembly
13.00 | MPG-plus | Assembly and operating manual | en | 389216
25
Adjustment dimensions
Size L1 [mm] Size L1 [mm]
MPG-plus 25 8.8 MPG-plus 40 4.8
MPG-plus 25-AS 2.0 / 2.5 MPG-plus 40-AS 2.9
MPG-plus 25-IS 7.8 MPG-plus 40-IS -17.8
MPG-plus 32 5.5 MPG-plus 50 4.3
MPG-plus 32-AS -4.0 MPG-plus 50-AS -2.2
MPG-plus 32-IS 1.7 MPG-plus 50-IS -14.8
5.3.3.2 Size MPG-plus 25 AS
For the variant "O.D. gripping" (AS) of the size25 a special bracket
must be mounted.
Ø Remove the standard bracket.
Ø Fasten the special bracket. Tighten the screws only slightly.
Ø Move the sensor into the bracket up to the stop.
Ø Tighten the screws at the bracket.
Ø Fasten the sensor using a threaded pin.
Tightening torque: 10 Ncm
Ø Check the protrusion of sensor L1, see table "adjustment
dimensions".
Ø Adjust the sensor, see assembly and operating manual of the
sensor.
To Next Page
Loading...
