Assembly
210.00 | PZN-plus | Assembly and Operating Manual | en | 389374 21
ð When mounting from the rear: use cylindrical pins for
fixing the product in place.
ð If necessary, use appropriate connection elements
(adapter plates).
ð Observe requirements for the adapter
plate, }5.2.1 [/22].
ð Observe the maximal tightening torque, admissible
screw-in depth and, if necessary, strength class.
6. Secure the gripper fingers to the base jaws, }5.2.1 [/21].
ð Use centering sleeves from the enclosed accessory pack.
7. If necessary, fit a pressure piece for spring-supported
positioning of the workpiece against a stop, }5.2.1.1 [/24].
8. Connect the sensor, see assembly and operating manual of
the sensor.
9. Mount the sensor, }5.3 [/26].
5.2 Connections
5.2.1 Mechanical connection
Evenness of the
mounting surface
The values apply to the whole mounting surface to which the
product is mounted.
Edge length Permissible unevenness
< 100 < 0.02
> 100 < 0.05
Tab.: Requirements for evenness of the mounting surface (Dimensions in mm)
Connections at the
base jaws
Size
①
Centering sleeve
②
Screws *
40 Ø4 M2.5 / 6
50 Ø5 M3 / 8
64 Ø6 M4 / 10
80 Ø8 M5 / 10
100 Ø10 M6 / 13
125 Ø10 M6 / 13
To Next Page
Loading...
Need help?
General
