Maintenance
210.00 | PZN-plus | Assembly and Operating Manual | en | 389374 55
1. Remove the compressed air lines.
2. Unscrew the screws (47) and remove the cover plate (5).
3. Mark the installation position of the piston (3) and the base
jaws (2) in the housing (1).
4. Clamp the gripper with suitable plastic base (101) between the
base jaws (2) and the cover (9) in a press (100), so that the 8
screws (46) still can be removed.
5. Unscrew the screws (46).
6. Open press (100) carefully.
7. Remove the cover (5).
8. Remove centering pins (55).
To Next Page
Loading...
