14 02.00|ROTA TP |en
Risk of fatal injury to operating personnel due to the workpiece
falling down or being flung out in the event of a power failure
In the event of a power failure, the lathe chuck's clamping force
may fail immediately and the workpiece may be released in an
uncontrolled manner. This poses a risk of death or injury to the
operating personnel and can result in serious damage to the au-
tomated system.
• The machine manufacturer and the operator of the machine
must carry out and document a hazard assessment and risk
analysis to ensure that suitable measures are taken to main-
tain the lathe chuck's clamping force until the machine comes
to a standstill and the workpiece can be secured (e.g. using a
crane or suitable lifting equipment).
• The machines and equipment must fulfill the minimum re-
quirements of the EC Machinery Directive; specifically, they
must have effective technical measures to protect against po-
tential mechanical hazards.
Possible risk of fatal injury to operating personnel if a jaw
breaks or if the lathe chuck fails because the technical data have
been exceeded and a workpiece is released or parts fly off
• The technical data specified by the manufacturer for using the
lathe chuck must never be exceeded.
• The lathe chuck may only be used on machines and facilities
that fulfill the minimum requirements of the EC Machinery Di-
rective; specifically, they must have effective technical
measures to protect against possible mechanical hazards.
To Next Page
Loading...
Need help?
General
