31
Power Chuck with extended and standard jaw stroke (LH)
Lathe chucks with dual stroke system (LH-serie) are not allowed to
be used for I.D. clamping. Moreover, no workpieces are allowed to
be clamped on the fast jaw stroke, since due to the long jaw
strokes the resulting clamping forces are lower (1). Please make
sure that the entire fast stroke plus at least 1/3 of the clamping
stroke (corresponding to the basic covering) of the TB-LH lathe
chuck is executed during workpiece clamping (2).
To Next Page
Loading...
Need help?
General
