01.00|1372106_A
FS3 138 PMI_AFS3 138 MMS |en
13
AFS3 138 MMS
The AFS3 138 MMS is a compact monitoring unit with two
monitoring control functions. It is fitted onto the housing of the
clamping module in clamping slide axis via 2 mounting threads
below the clamping slide bore holes and 2 M4 screws. The
mounting location depends on the quick-change pallet system
type. For the NSE3 138(-K) version, the unit can be adapted to one
of the two clamping slides. For the size NSE3 138-V1(-K), the fitting
position of the monitoring system is specified to be opposite the
torque pin nut. In the housing of the AFS3 138 MMS monitoring
system, an electronic magnetic switch is fitted with two
programmable switching points. On the clamping slide, an adapter
piece with an inserted round magnet is applied. The system
detects via the electronic magnetic switch the precise clamping
slide position in the "unlocked" or "clamped" operating condition.
The switching points of the magnetic switch can be precisely
taught in and saved. The monitoring of the workpiece system
control takes place with an inductive proximity switch which is
below a raising base in the housing of the monitoring system.
Note
To ensure a reliable evaluation of the clamping slide position, the
electronic magnetic switch must be precisely taught into the
stroke position of the quick-change pallet system. A readjustment
of the magnetic switch may be required after longer time intervals.
For reliable functionality, the inductive proximity switch must be
positioned at a flush installation height in the installation housing.
To Next Page
Loading...
