Sensor for presence monitoring of the clamping pallet
36 01.00|1372106_AFS3 138 PMI_AFS3 138 MMS |en
Sensor for presence monitoring of the clamping
pallet
Both monitoring systems are equipped with an inductive proximity
switch for monitoring the presence monitoring of a clamping pallet
or workpiece.
Information on handling sensors is available at
www.de.schunk.com or from SCHUNK contact persons. Technical
data for the sensors can be found in the data sheets (included in
the scope of delivery or under www.de.schunk.com). The used
proximity and magnetic switches are protected against polarity
reversal and short-circuit-proof.
For the proper use of the proximity switches and sensors, observe
the following:
• Do not pull on the cable of the sensor.
• Do not dangle the sensor from the cable.
• Do not excessively tighten the mounting screws or clips.
• Do not exceed the permissible bending radius of the cable (☞
catalog specifications).
• Prevent proximity switch from coming into contact with hard
objects or with chemicals; in particular, nitric, chromic or
sulfuric acid
• Proximity switches are electronic components which can react
sensitively to high-frequency interference or electromagnetic
fields.
• Check that the cable is correctly connected and installed.
• There must be sufficient distance between the switches and
sources of interference and their supply cables.
To Next Page
Loading...
