Schwinn 430 - Safety Warning Labels and Serial Number; FCC Compliance

4
Maintenance
Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is neces-
sary to do the necessary tasks.
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure
that regular maintenance is done. Worn, damaged or loose components must be repaired or replaced
immediately. Only manufacturer supplied components can be used to maintain and repair the equip-
ment.
WARNING
ATTENTION
DANGER
IMMEDIATE ACTION REQUIRED
CAUTION
To reduce the risk of electrical shock or unsupervised usage of the equipment, always
unplug the power cord from the wall outlet and wait 5 minutes before cleaning, maintaining
or repairing this machine. Place the power cord in a secure location.
Whendisposingofoldparts,obeytheapplicablelocalandprovincialrequirements.
Daily:
Before each use, examine the exercise machine for loose, broken, damaged,
or worn parts. Do not use if found in this condition. Repair or replace all parts at
therstsignofwearordamage.Aftereachworkout,useadampclothtowipe
your machine and Console free of moisture.
Note:AvoidexcessivemoistureontheConsole.
Weekly:
Checkforsmoothrolleroperation.Wipethemachinetoremovedust,dirt,or
grime. Clean the rails and surface of the rollers with a damp cloth.
Apply silicone lubricant to a dry cloth and wipe the rails to eliminate roller noise.
Silicone lubricant is not intended for human consumption. Keep out
of reach of children. Store in a safe place.
Note: Do not use petroleum based products.
Monthly
or after 20 hours:
Make sure all bolts and screws are tight. Tighten as necessary.
NOTICE: Do not clean with a petroleum based solvent or an automotive cleaner. Be sure to keep the Console free
of moisture.
FCC Compliance
Changes or modications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
The machine and power supply comply with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,including
interference that may cause undesired operation.
Note:ThismachineandpowersupplyhavebeentestedandfoundtocomplywiththelimitsforaClassBdigital
device,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainst
harmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiateradiofrequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescause
harmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,the
user is encouraged to try to correct the interference by one or more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
• Consult the dealer or an experienced radio/TV technician for help.