Schwinn 430 - Specifications and Pre-Assembly; Before Assembly; Basic Assembly Tips

5
Moving the Machine
The machine may be moved by one or more persons depending on their physical abilities and capacities.
Make sure that you and others are all physically fit and able to move the machine safely.
1. Remove the power cord.
2. Use the Transport Handle to carefully lift the machine onto the transport rollers.
3. Push the machine into position.
4. Carefully lower the machine into position.
NOTICE: Be careful when you move the elliptical. All abrupt motions can
affect the computer operation.
Leveling the Machine
The machine needs to be leveled if your workout area is uneven or if the Rail Assembly is slightly off the floor. To adjust:
1. Place the machine in your workout area.
2. Safely stand on the back of the Rail Assembly for approximately 20 seconds.
3. Step off the machine.
4. Loosen the locking wing nuts and adjust the
levelers until they all contact the floor.
Do not adjust the levelers to such a
height that they detach or unscrew from
the machine. Injury to you or damage to
the machine can occur.
5. Adjust until the machine is level. Tighten the
locking wing nuts.
Make sure the machine is level and stable before
you exercise.
USB Charging
IfaUSBDeviceisattachedtotheUSBPort,thePortwillattempttochargetheDevice.ThepowersuppliedfromtheUSB
PortmaynotbeenoughtooperatetheDeviceandchargeitatthesametime.