56
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall
outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a
secure location.
Note: Your machine may not match the image. For reference only.
1. Using a 6mm hex wrench and a 13mm wrench, remove the 2 indi-
cated bolts from the Lower Handlebar Arms and Pedals. Set the hardware
safely aside for reassembly.
Be aware that the Handlebar Arms will be loose and may
pivot when the hardware is removed. This step may require
two people.
2. Using a small flathead screwdriver, pry the Caps from the Lower
Handlebar Arms.
3. Using a 13mm wrench and a pair of pliers, remove the hardware from
the Lower Handlebar Arms and the Arm Pivot Rod. Remove
the hardware and the Upper and Lower Handlebar Arms.
Set them safely aside for reassembly.
Note: The hardware on both ends of the Arm Pivot Rod
will need to be held to remove it.
6mm
X2
X2
X2
13mm
To Next Page
Loading...
