24
7) Bilge Pump Switch
A 2-position push type switch.
Press switch to ON position when a
manual operation is required (after clean-
ing, storage, etc.).
Press to OFF position when bilge is dry.
CAUTION: Using the bilge pump for
a prolonged time when the engine is
not running will discharge the bat-
tery.
NOTE: The bilge pump may be operat-
ed without the safety lanyard on its
switch.
CAUTION: Ensure to always turn
pump OFF when bilge is dry or be-
fore operating the engine above
idle. Bilge pump will then switch to
automatic mode.
Automatic Bilge Pump
An automatic bilge pump will evacuate
water from the bilge. A water sensor
detects the water which activates the
bilge pump. After the water is pumped
out, the pump shuts-off automatically.
This automatic mode is working at all
times: with/without safety lanyard on
its switch and with/without engine run-
ning.
8) Bilge Air Blower Switch
A 2-position push type switch. When
ON, it ventilates the engine compart-
ment.
CAUTION: Using the bilge blower
for a prolonged time when the en-
gine is not running will discharge
the battery.
Blower should be turned off during
boat operation.
9) Horn Switch
A 2-position push type switch.
F00H1HY
WARNING
Always use blower for a minimum
of 5 minutes prior to engine start-
ing then, turn it OFF above idle
speed. Use of the bilge blower
should never replace “smelling”
for gasoline vapors.
F00H1LY
F00H1JY
lmo2001-004a.book Page 24 Friday, November 3, 2000 3:27 PM
To Next Page
Loading...
Need help?
General
