FINAL PREPARATION
123
F18F076
To adjust th
rottle cable, loosen jam nut [2] then
turn adjustment nut [1] as necessary.
WARNING
Make s ure idle speed screw contacts
throttle cam when throttle lever is fully
released
at handlebar.
CAUTION: Never attempt to adjust idle speed
through throttle body tamper proof screw.
If so, it would impair idle speed stability.
Besides, no adjustment could be performed
by deal
er nor factory to correct idle speed.
Throttle body would need to be replaced.
Also take into account that it might change
engine emission level and engine might not
meet EPA/CARB requirements.
For more informations on throttle cable adjustment,
refer to appropriate Sea-Doo SHOP MANUAL.
FINAL INSPECTION
General Instructions
Make sure that tool kit and fire extinguisher are
pro
perly secured at their proper location.
Complete PREDELIVERY CHECK LIST
following all instructions.
Test ride watercraft.
Decal Prote ctive Films
Protective film on all decals must be removed.
Slowly peel off protective films.
Cleaning the Watercraft
Clean watercraft.
CAUTION: Clean apparent fiberglass and
plastic parts with a clean cloth and soapy
water or isopropyl alcohol. Never use
strong detergent, degreasing agent, paint
thinner, acetone, etc. Do not apply isopropyl
alcohol dire
ctly on decals.
Accessories
On some models, accessories, such as
wakeboard rack, GPS (Global Positioning
System), etc., must be installed prior to delivering
vehicle. R
efer to appropriate OPERATOR'S
MANUAL for complete installation procedure.
NOTE: Procedures must be explained
to purchaser.
DELIVERY TO PURCHASER
General Instructions
Where possible, give a brief demo ride and
explain watercraft operation.
Explain
, complete and return WARRANTY
REGISTRATION CARD (legal requirement).
Purchaser must sign the PREDELIVERY
CHECK LIST.
Give to purchaser:
– Operator's guide
–SafetyDVD
– Copy of the PREDELIVERY CHECK LIST
Fuel System
Explain to purchaser that it might be necessary
to remove and install safety lanyard 2 or 3
times to initially feed fuel system.
Han
dlebar Tag
A tag is tied to handlebar. Leave it there until
delivery and make sure purchaser reads it.
Break-In Period
Explain to purchaser that with Sea-Doo watercraft
po
wered by Rotax
®
engines, a break-in period
of 10 hours is required before continuous
operation at full throttle. To achieve a good
break-in, v ary engine speed every few minutes
with brief wide open throttle accelerations of u p
to 15 seconds. Continued wide open throttle
runs and prolonged cruising without speed
18 / 22 2007-2 Predelivery
To Next Page
Loading...
