SeaDoo GTX+ User Manual

SET-UP
SET-UP
Venturi
Model(s): All
1
F08A076
Secure lower portion of the venturi [1] with:
– 2 hexagon
al bolts (with scotch grip) from
predelivery kit (refer to table below).
– 2 M8 flat washers (previously removed).
Models Bolt Torque
147A / 147B / 157A /
157B / 237A / 237B /
247A / 247B / 287A /
287B / 287C / 307A /
307B
M8 x 50
with
scotch-grip
177A / 177B / 177C /
177D / 187A / 187B /
217A / 217B / 217C /
217D / 257A / 257B /
267A / 267B
M8 x 40
with
scotch-grip
21 N•m
(15 lbf•ft)
Battery P reparation and
Installation
Refer to appropriate SHOP MANUAL for proper
procedure to activate battery.
Model(s): All
Install battery in battery support in engine
compartment.
Secure RED positive cable to battery
positive post with:
– 1 hexagonal bolt,
– 1 flat washer and
– 1 nut, all from predelivery kit.
Apply dielectric grease (P/N 293 550 004)
on positive battery post.
Cover positive battery post with rubber boot.
Model(s): RXP
sbl2006-002-100_a
NOTE: On RX
P models, RED positive cable
[1] must be installed at a 45° angle while
BLACK negative cable [2] is still accepted at
a 90° angle; refer to photo.
Model(s
): All
Secure BLACK negative cable to negative
battery post with:
– 1 hexagonal bolt,
– 1 flat washer and
– 1 nut, a ll from predelivery kit.
Apply dielectric grease (P/N 293 550 004)
on negative battery post.

WARN
ING
Always connect battery cables exactly in this
specific order. Connect RED positive cable
first, then BLACK negative g round cable.
Secure battery with supplied
– bracket,
– 2 flat washers and
– 2 nuts.
Remove red plastic cap from battery vent
elbow (if so equipped).
Install battery vent tube.

WARNING
Ensure vent tube is not kinked or obstructed.
Battery vent tube must be properly installed.
Predelivery 2007-2 5 / 22

SeaDoo GTX+ Specifications

General

Manufacturer	Sea-Doo
Model	GTX+
Fuel Type	Unleaded gasoline
Category	Personal Watercraft
Fuel Capacity	18.5 gallons
Seating Capacity	3