EasyManuals Logo

SeaDoo GTX+ User Manual

SeaDoo GTX+
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
SET-UP
Storage Cover Shock
Installation On GTX STD,LTD
and Wake
smr2007-034-008_a
Snap the top of shock (body side) in
inner shell s ocket.
Place the bottom of shock [3] (rod side) against
the bump [2
] on the shock support [1] and close
storage compartment cover. The bottom of the
shock will be i nserted in its place automatically.
FINAL PREPARATION
Steering Alignment
Model(s): All
All adjustments have already been performed
at factory. If readjustments are needed,
check s
teering alignment procedure in
appropriate SHOP MANUAL.
O.P.A.S.
TM
System Alignment
Model
(s): All
All adjustments have already been performed
at factory. If readjustments are needed,
check O .P.A.S. system alignment procedure
in ap
propriate SHOP MANUAL.
Fuel
Model(s): All
At predelivery, we suggest dealers to fill fuel
tank with recommended fuel type as described
in SPECIFICATIONS TABLE.
NOTE: Never add oil in fuel.
CAUTION: Never use fuel c ontaining more
than 10% alcohol (ethanol or methanol).
WARNING
Fuel is flammable and explosive under
certain c onditions. Always work in a
well ventilated area.
It might be necessary to remove and install safety
lanyard2or3
times to initially feed fuel system.
NOTE: This procedure should be explained
to purchaser at delivery.
NOTE: Verify fuel line connectors prior to
powering-up ECM. This verification must be
done visually as well as manually by physically
checking each connection.
WARNING
Never install safety lanyard prior to checking
fuel line connector tightness.
Fuel Sys
tem Pressurization
Model(s): All
WARNING
At PDI, or whenever doing any type of repair
on watercraft or if any components of fuel
system
are disconnected, a pressure test must
be done before starting engine. Ensure to
verify fuel line ends for damage. Always cut
damaged end before reinstallation.
For fu
el system pressure test procedure, refer
to appropriate SHOP MANUAL.
Coolant Level
Mode
l(s): All
WARNING
Check coolant level with engine cold.
Never add coolant in cooling system
when engine is hot.
14 / 22 2007-2 Predelivery

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SeaDoo GTX+ and is the answer not in the manual?

SeaDoo GTX+ Specifications

General IconGeneral
ManufacturerSea-Doo
ModelGTX+
Fuel TypeUnleaded gasoline
CategoryPersonal Watercraft
Fuel Capacity18.5 gallons
Seating Capacity3

Related product manuals