Seaga JDL-2 COMBO - FAQ - Environment and Vending; Common Questions and Answers

64JDL V1.0 8 2022
3. Clean changer.
Q. Why won’t the unit take more than 3 - $1 bills, or more than 1 - $5 bill?
A. The VMC protects the amount of change in the changer and will only allow the bill acceptor to take
bills up to the highest vend price in the machine. For example, if your highest vend price is $3, aer
inserng 3 - $1 bills or 1 - $5 you will not be able to insert more bills.
Q. In the event of a power outage, will I have to reprogram my prices, sengs, etc.?
A. No, your sengs are stored.
Q. Are the prices preprogrammed at the factory? Is there a default seng for all of the programming
funcons?
A. Yes, the prices are pre-programmed at the factory to $1. However, programming the price sengs
is a great way to get familiar with your machine while you are in test mode and prior to locang the
machine. Your rst-hand knowledge will allow you a greater understanding of how the equipment
works.
Q. How oen should I clean my payment systems?
A. This will depend on how much trac you have at your machine – the more money inserted, the
direr the payment systems will become. Clean your payment systems on a monthly basis to begin
with. Lengthening the me between cleanings is at your own discreon.
Drink unit temperature and refrigeraon:
Q. What type of environment is the equipment designed for?
A. The machine is specically designed for indoor use only. Opmal locaon temperature is 75° F, with
40% RH. Avoid placing unit in direct sunlight.
Q. How do I clean my condenser?
A. Remove the front boom panel of the refrigeraon unit. Brush the dirt and dust from the condenser
ns. You can also blow canned air (available at oce supply/computer stores) on the condenser or
vacuum clean it. Do not damage the ns of the condenser while cleaning. Reassemble the front
boom panel aer cleaning.
Q. How do I set my temperatures, and what is the factory recommended low and high sengs?
A. The unit is pre-set by the factory to the industry standard. See Set Point secon of the programming
informaon to change the sengs.
Q. My drink selecons are not cold enough. How do I get them colder?
1. Make a small adjustment to the Set Point menu on the VMC. This should be done with extreme
cauon!
2. Clean condenser coil (see Refrigeraon secon of this manual). The coil should be clean and lint
free, if dirt or lint build-up is on coil, this will restrict air ow and cause the compressor temperature
to rise above operang temperatures and compromise cooling.
3. Ensure condenser fan and evaporator fans are running.
4. Ensure your drink vendor is placed in a locaon that it is designed for, which is indoors only.
Installaon in outside or environments without climate control will compromise cooling, potenally