Seakeeper 3 - Stabilization

INSTALLATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 3 90378 4 15 of 15
Section 1: MECHANICAL INSTALLATION
1.6 Removal and Disposal
1.6.1 Removal
This section details basic instructions for removal of a Seakeeper 3 from a boat. The overall
basic instructions are to reverse the installation instructions:
1) Disconnect seawater pump from heat exchanger and power connector on wiring
harness.
2) Drain heat exchanger of all seawater.
3) Disconnect both Seakeeper input power cables.
4) Remove all installation fasteners.
5) Remove the Seakeeper unit using a spreader bar.
1.6.2 Disposal
DO NOT disassemble the Seakeeper to a greater degree than necessary for removal from the
boat. DO NOT dispose of a Seakeeper unit in a landfill. The unit must be shipped back to
Seakeeper.