Seakeeper 3 - Electrical Equipment Ground Connections; Seakeeper to Vessel Ground Connection Instructions

INSTALLATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 3 90378 4 10 of 12
Section 2: ELECTRICAL INSTALLATION
2.3 Electrical Equipment Ground Connections
1. SEAKEEPER TO VESSEL GROUND CONNECTION INSTRUCTIONS
a. Connect the Seakeeper foundation to vessel ground.
i. Install CABLE 6 (4AWG or 25 mm
2
, Customer Supplied) from the M6
brass ground stud on the rear brace to a suitable vessel ground. Note:
ONLY USE THIS LOCATION FOR GROUNDING THE SEAKEEPER TO
THE VESSEL GROUND.
FIGURE 11 – GROUND STUD ON FRAME
GROUND
STUD