From Configure Monitors screen, use the UP/DOWN scroll button to
select Reset Factory Default, and press the OK button.
It will restore the default configuration settings in the Configure
Monitors menu, and delete any customised settings. In this case,
Spark IGN Required Monitors and Compression IGN Required
Monitors will include all the available monitors, and the Allowed
INC Monitors will be set to 1.
The tool will display an information message to ask for your
confirmation. Select Yes to proceed and No to exit without change.
Unit of Measure
Metric is the default measurement unit.
1) From System Setup screen, use the UP/DOWN scroll button to
select Unit of Measurement and press the OK button.
2) From Unit of Measurement screen, use the UP/DOWN scroll button
to select the desired unit of measurement. (Figure 3.6 )
Figure 3.6
3) Press the OK button to save your selection and return to previous
menu.
Key Beep Set
This function allows you to turn on/off the build-in speaker for key
pressing.
Unit of Measure 1/2
English
Metric
?
To Next Page
Loading...
