The default setting is Beep On.
1) From System Setup screen, use the UP/DOWN scroll button to
select Key Beep Set and press the OK button.
2) From Key Beep Set menu, use the UP/DOWN scroll button to
select Beep ON or Beep OFF to turn on/off the beep.
Figure 3.7
3) Press the OK button to save your selection and return to
previous menu.
Status Beep Set
The default setting is Beep On.
This function allows you to turn on/off the build-in speaker for the
LEDs in diagnostic testing. Different audio tone corresponds to
different LED lamp. This function is invaluable when performing
diagnostics alone, or working in bright areas where LED illumination
alone is not sufficient.
1) From System Setup screen, use the UP/DOWN scroll button to
select Status Beep Set and press the OK button.
2) From Status Beep Set menu, use the UP/DOWN scroll button to
select Beep ON or Beep OFF to turn on/off the beep. (Figure
3.8)
Key Beep Set 1/2
Beep ON
Beep OFF
?
To Next Page
Loading...
