Name: Seastar Solutions i7700
Brand: Seastar Solutions
Rating: 4 (1 reviews)

To Next Page

To Previous Page

C-5

C.4 Actuator Setup

C.4.1 Step 1 – Actuator Conﬁguration Using Datalink

This step will establish communication between the shift and throttle

actuators and Datalink and will conﬁgure the shift and throttle actuator

settings. From the factory, all actuators default to being Port Shift

actuators. This section will assign the correct function to each of

the actuators.

Ensure mechanical cables are not connected to the actuators at

this point.

CAUTION

Procedure

1. In the Datalink workspace you should see two Port Shift Actuators

for each engine, as shown in ﬁgure C-3 below. Click on the + beside

an actuator to view the part and serial number information

associated with it.

Figure C-3. Shift/Throttle actuator conﬁguration.

Questions and Answers:

Need help?

Do you have a question about the Seastar Solutions i7700 and is the answer not in the manual?

Seastar Solutions i7700 Specifications

General