D-1
© 2017 SeaStar Solutions i7700 Installation Supplement, Rev. B
From time to time it may become necessary to update the Datalink
notebook software and the i7700 component firmware as new versions
become available.
Check www.optimusdealers.com for latest available firmware. The
updates are packaged in a single download file called ‘Optimus and
Optimus 360 Datalink Updater Version X’, where X indicates the revision.
A readme file describes the nature of the updates, the component
revision files included in the package, and any special instructions.
ALWAYS read the readme file prior to updating. The readme file can
be accessed from the Datalink ‘Help’ menu. Click ‘Help,’ then click
‘readme.txt’ to view the file.
When run, the Updater will first install the latest version of Datalink
on your computer, then automatically load the latest firmware files
to the notebook computer and put them
in the [Desktop\Optimus
Firmware] folder. Each component update file
will be in a separate
folder with the component name. See Figure D-1.
NOTE: The installer only loads the required files to the computer; it
does NOT perform the actual component updates. Refer to section
D.2 for detailed component updating instructions.
Figure D-1. Desktop\Optimus Firmware – Folder Structure.
This section contains instructions for i7700 Shift and Throttle System,
Optimus EPS and Optimus 360 systems.
APPENDIX D UPDATING FIRMWARE
To Next Page
Loading...
Need help?
General
