Seatex DPS 132 Installation Manual, rev. 0 Installation
37
3.9.5 Output mode and interval
OUTPUTMODE_1 0
It is possible to configure the data telegrams to event-
driven or timer-driven output. When timer-driven mode
is selected, the output interval between the telegrams
can be decided.
Default Output Mode is 0, which is event-driven.
OUTPUTINTV_1 1000 [ms]
Default Output Interval is 1000 ms.
3.9.6 UTM mode and zone
It is possible to specify which UTM mode to use when the telegram ABBDP, which output
UTM position, is selected. The following UTM modes are available:
UTM_MODE_1 0
0:
Auto extended: zone option is only applicable
between 56 degrees to 64 degrees north and 3
degrees to 6 degrees east. The 32V zone is extended
west to 3 degrees east, so when selecting the Auto
extended zone in this area, zone 32V is used. When
outside the current area and Auto extended zone is
selected, the used zone is equal to the zone used
when selecting Auto zone.
1:
Auto: the system zone is automatically calculated in
accordance with the position co-ordinates.
UTM_ZONE_1 -1
UTM_ZONE_OFFSET_1 0.0 [deg]
2:
Manual: makes it possible to define which Zone and
Zone offset to use. When Manual mode is selected,
UTM zone and UTM zone offset must be specified.
The UTM zone offset option allows a fixed offset to
be applied to the longitude degrees. The UTM zone
can be offset up to ±3 degrees. The zone offset is
typically applied where the maps used have an offset.
Different UTM modes and zones may be set on each DP port.
UTM mode is default set to 0, UTM zone is default set to –1 and UTM zone offset is default
set to 0.0.
To Next Page
Loading...
