Seg System A2 H15 User Manual

5.3 Printout
Printout may be initiated by pushing key “B” on the front panel. Correct communication settings must be made
under the “COM SETUP” before connection to printer.
Refer to section 3.5.1
The printed information depends on what selections have been made for display indication.
Refer to the explanations below:
18-08-16 S44-H15E 5-3
S-E-G SYSTEM A2-H15 INSTRUCTION
> Flow 325tþ>
Zero Print
-
D
B
A C
If “Zero I Print” indication is toggled in the lower display, key B will initiate printout of the selected indication
on the upper row with time and date.
In the example above, “07.02.21 11:18 Flow 325th” will be printed.
Subsequently, the following will be printed if corresponding indications is selected in the upper row:
“07.02.21 11:19 Sub-1 Total 35.2 t”
“07.02.21 11:20 Sub-2 Total 18.3 t”
“07.02.21 11:21 Master Total 227.7 t”
Remote printout via terminals 41,42 will print Subtotal2 only, with automatic zeroset for each printout.
NOTE! Printout will only be executed once. No new printout can be executed until the totaliser value has been
incremented with 1 digit (Not indicating zero).
If any other indication than “Zero I Print” is indicated in the lower display row, that indicated information will
be printed. Refer to example below:
> Flow 325tþ>
Sub1Tot 35.2 t
The indication to the left will print:
“07.02.21 11:19 Sub-1 Total 35.2 t”

Seg System A2 H15 Specifications

General

Brand	Seg
Model	System A2 H15
Category	Controller
Language	English