EasyManua.ls Logo

Sega Dinosaur King - PRECAUTIONS REGARDING INSTALLATION LOCATION; LIMITATIONS OF USAGE

Sega Dinosaur King
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause a re, electric shock,
injury and/or malfunction.
・ Places subject to rain or water leakage, or places subject to high humidity in
the proximity of an indoor swimming pool and or shower, etc.
・ Places subject to direct sunlight, or places subject to high temperatures in the
proximity of heating units, etc.
・ Places lled with inammable gas or vicinity of highly inammable/volatile
chemicals or hazardous matter.
・ Dusty places.
・ Sloped surfaces.
・ Places subject to any type of violent impact.
・ Vicinity of anti-disaster facilities such as re exits and re extinguishers.
・ The operating (ambient) temperature range is from 5℃ to 30℃.
● Be sure to check the Electrical Specications. Ensure that this product
is compatible with the location's power supply, voltage and frequency
requirements. A plate describing Electrical Specications is attached to the
product. Non-compliance with the Electrical Specications can cause a re and
electric shock.
● This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a re and electric shock.
● Ensure that the indoor wiring for the power supply is rated at 7A or higher (AC
single phase 100V〜120V area), and 4A or higher (AC 220V〜240V area). Non-
compliance with the Electrical Specications can cause a re and electric
shock.
● Be sure to use an independent power supply equipped with a surge-
suppressor. Using a power supply without a surge-suppressor can cause an
outbreak of re if a power surge occurs.
● Putting many loads on one electrical outlet can cause generation of heat and a
re resulting from overload.
When using an extension cord, ensure that the cord is rated at 7A or higher (AC
100V 〜 120V area) and 4A or higher (AC 220V〜240V area). Using a cord rated
lower than the specied rating can cause a re and electric shock.
2. PRECAUTIONS REGARDING INSTALLATION LOCATION
WARNING
WARNING
21 LIMITATIONS OF USAGE

Table of Contents

Related product manuals