Sega Rambo - System Test Mode

29
1
29
9
EXPLANATION OF TEST AND DATA DISPLAY
7-2 SYSTEM TEST MODE
● The details of changes to Test Mode settings are saved when you exit from Test
Mode by selecting EXIT from the system Test Mode menu. Be careful because if
the power is turned off before that point, changes to the settings will be lost.
● Use with the specied settings. If settings other than those specied are used,
inappropriate operations or malfunction may occur.
● Go to BOOKKEEPING in GAME TEST MODE to access this product’s data.
● Read the LINDBERGH RED EX service manual that comes with the product for
details on the System Test Mode. However, you should perform the settings for
this product according to the manual you are reading.
In the System Test Mode, the main activities include checking LINDBERGH RED EX information and actions and
the setting of coin/credit. Also, a screen appears for checking screen adjustments. For details, see the LINDBERGH
RED EX service manual, which is provided with the product.
Use the following settings with this product. If the settings are not as specied, error messages might appear and
operations might not be normal.
NOTE: If you proceed to the game screen using different settings, you will get an “ Error 200” message on the
screen. If that happens, go back to the SYSTEM TEST MENU and change the settings to the following:
COIN CHUTE TYPE COMMON
SERVICE TYPE COMMON
COIN ASSIGNMENTS
1
When the TEST Button is pressed, the System
Test Menu Screen (SYSTEM TEST MENU)
appears.
 SYSTEMTESTMENU
SYSTEMINFORMATION
STORAGEINFORMATION
JVSTEST
MONITORTEST
SPEAKERTEST
COINASSIGNMENTS
CLOCKSETTING
NETWORKSETTING
GAMETESTMODE
－＞ EXIT
 SELECTWITHSERVICEANDPRESSTEST
9-2 FIG. 01 System Test Menu Screen