46
13
COIN SELECTOR
4
Remove cradle.
When removing the retaining ring (E ring), be careful not
to bend the rotary shaft.
13-1 FIG. 02
5
Use soft cloth to wipe dirt from rotary shaft and bearing.
6
After wiping off dirt, wipe away moisture with a dry cloth and make sure that the coin selector is completely
dry.
8-2 Removing a Jammed Coin
When the REJECT button fails to refund coins, open the coin chute door and open the selector gate. Once the
jammed coin is removed, insert a standard coin to ensure that the selector is working properly.
8-3 Coin Insertion Test
Carry out a coin insertion test once per month. At the same time, check the following points:
□ Does the coin meter count properly?
□ Do coins drop into the cashbox correctly?
□ Are coins rejected when inserted while holding down the REJECT button?
□ Are extra coins and incorrect coins properly returned?
13-3 FIG. 01
REJECT BUTTON
INSERTION SLOT
COIN METER
CASHBOX
REFUND SLOT
To Next Page
Loading...
