Sega Rambo - Input Test

33
1
33
9
EXPLANATION OF TEST AND DATA DISPLAY
7-3-2 INPUT TEST
Select INPUT TEST to display the following screen and check the status of input devices.
This test should be used periodically to check that each input device is functioning correctly.
1
On the GAME TEST MODE screen, select INPUT TEST and press the TEST Button. The INPUT TEST
screen appears.
 INPUTTEST
 PLAYER1 PLAYER2
START OFF OFF
CONTROLLERTRIGGER OFF OFF
CONTROLLERBUTTON OFF OFF
CONTROLLERX ** **
CONTROLLERY ** **
SCREENIN OUT OUT
SERVICE  OFF
TEST  OFF
 PRESSTESTANDSERVICETOEXIT
9-3-2 FIG. 01
2
Manipulate each switch, etc., to check screen display.
START
This will say ON when the START buttons are being pressed and OFF
when they are released.
CONTROLLER
TRIGGER
This will say ON when the triggers on the controllers are being pulled and
OFF when they are released.
CONTROLLER
BUTTON
This will say ON when the buttons on the controllers are being pressed and
OFF when they are released.
CONTROLLER X This shows the aim location for the X direction on the controllers.
CONTROLLER Y This shows the aim location for the Y direction on the controllers.
SCREEN IN
This will say IN when the controllers are aimed inside the screen and OUT
when they are aimed outside the screen.
SERVICE
This will say ON when the SERVICE button is being pressed and OFF
when it is released.
TEST
This will say ON when the TEST button is being pressed and OFF when it
is released.
3
When all checks are completed, press the TEST Button and the SERVICE Button simultaneously. The
GAME TEST MODE screen reappears.