Sega Rambo - Precautions Regarding Installation Location; Installation Site Warnings; Usage Limitations

3
1
3
2
PRECAUTIONS REGARDING INSTALLATION LOCATION
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause a re, electric
shock, injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the
proximity of an indoor swimming pool and/or shower, etc.
- Places subject to direct sunlight, or places subject to high temperatures in the
proximity of heating units, etc.
- Places lled with inammable gas or vicinity of highly inammable/volatile
chemicals or hazardous matter.
- Dusty places.
- Sloped surfaces.
- Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as re exits and re extinguishers.
- Areas where the temperature exceeds the applicable temperature (ambient
temperature) range of 10 to 30 degrees centigrade.
2-1 LIMITATIONS OF USAGE
● Be sure to check the Electrical Specications. Ensure that this product
is compatible with the location's power supply, voltage, and frequency
requirements. A plate describing Electrical Specications is attached to the
product. Non-compliance with the Electrical Specications can cause a re and
electric shock.
● This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a re and electric shock.
● Ensure that the indoor wiring for the power supply is rated at 15 A or higher (AC
single phase 100 V ~ 120 V area), and 7 A or higher (AC 220 V ~ 240 V area).
Non-compliance with the Electrical Specications can cause a re and electric
shock.
● Be sure to use an independent power supply equipped with an earth leakage
breaker. Using a power supply without an earth leakage breaker can cause an
outbreak of re if a power surge occurs.
● Putting many loads on one electrical outlet can cause generation of heat and a
re resulting from overload.
● When using an extension cord, ensure that the cord is rated at 15 A or higher
(AC 100 V ~ 120 V area) and 7 A or higher (AC 220 V ~ 240 V area). Using a cord
rated lower than the specied rating can cause a re and electric shock.