● When moving the machine, be sure to pull out the plug from the power supply.
Moving the machine with the plug still inserted can cause the power cord to be
damaged, resulting in a re and/or electric shock.
● When moving the machine on the oor, retract the adjusters, and ensure that
the casters make contact with the oor. Pay careful attention so that the casters
do not run over power cords and earth wires. Damaging the power cords can
cause an electric shock and/or short circuit.
● When lifting the cabinet, be sure to hold the handles and the bottom part.
Lifting the cabinet by holding other portions may damage parts and installation
portions due to the empty weight of the cabinet, and may cause personal injury.
● When moving the DLP projector, do not push it from the rear side. Push it from
sideways. Pushing the DLP projector from the rear side can have the DLP
projector fall down, causing personal injury, etc. In case the oor has slanted
surfaces or step-like differences, be sure to move the machine by 2 or more
persons.
PRECAUTIONS WHEN MOVING THE MACHINE
5
Do not hold or press the plastic parts as indicated by the Figure. Failure to observe
this instruction may break the parts, and eventually the broken pieces may cause
a personal injury.
● If the machine is going to be moved somewhere on a different level, disassemble
it into the individual units before doing so. If the machine is tilted or the cabinet is
set on an uneven surface the joints may break.
● Do not allow ropes to come in contact with the surface of the machine directly or
they may scratch it. Put some kind of protective material under the rope where it
will touch the machine.
● When moving the cabinet, do not hold it by the control unit or pull on the control
unit. Doing so could damage the parts or cause them to become deformed.
To Next Page
Loading...
