108
Removing/Installing the Fenders
Tools Required: T15 six-lobe wrench, Torque wrench with T15 six-
lobe bit.
To remove the Fenders (see Figure 40):
1. Make sure the Segway PT is unplugged and powered off.
2. Remove the Tire/Wheel Assembly.
For more information, see “Removing the Tire/
Wheel Assembly” on page 106.
3. Using a T15 six-lobe wrench, remove the 4 fasteners which
attach the Fender to the Gearbox.
4. Remove the Fender.
To install the Fenders (see Figure 40):
1. Position the Fender so it aligns with the holes in the Gearbox.
2. Thread the 4 fasteners through the Fender to the Gearbox and
tighten to 1.6 Nm (1.2 ft-lb).
3. Reseat the Tire/Wheel Assembly.
For more information, see “Installing the Tire/
Wheel Assembly” on page 107.
Figure 40. Servicing the Fenders
To Next Page
Loading...
