96
Attaching the LeanSteer Frame
Tool Required: Torque wrench with 5mm bit.
To attach the LeanSteer Frame to the Powerbase:
1. Make sure the Segway PT is unplugged and powered off.
2. Slide the LeanSteer Frame onto the Pivot Base Assembly, as
shown in Figure 31:
Figure 31. Attach Handlebar/LeanSteer Frame to the Pivot Base
Assembly
3. If the Wedge Clamps are not installed, install each Wedge
Clamp, curved side facing down, on either side of the LeanSteer
Frame base.
4. Loosely thread in the fastener.
LeanSteer Frame
Pivot Base Assembly
To Next Page
Loading...
