113
English
English
Installing/Removing the InfoKey
Controller Dock
Tool Required: 3mm hex wrench, Torque wrench with 3mm bit.
To install the InfoKey Controller Dock:
1. Make sure the Segway PT is unplugged and powered off.
2. Place the InfoKey Controller Dock against the upper LeanSteer
Frame with the Release Tab oriented at the bottom, as shown in
Figure 44.
3. Thread the 3mm fastener through the hole in the top of the
InfoKey Controller Dock and into the upper LeanSteer Frame.
4. Tighten the fastener to 2.0 N-m (18 in-lbf).
To Next Page
Loading...
