130
Diagnosing Errors with InfoKey
Controller Icons
InfoKey Controller icons assist you in diagnosing certain errors.
Match the icon shown in your InfoKey Controller display to those in
the tables in this section to identify and attempt to correct the fault.
Startup Error Conditions
If you attempt to power on the Segway PT and an error condition
occurs that prevents the Segway PT from powering on and entering
Standby Mode, the icons shown in Table 14 will appear on the
InfoKey Controller.
To clear these conditions, follow the instructions in the
Recommended Action column in Table 14.
Do not step onto the Segway PT Mats until you have cleared all
error conditions and have confirmed the Segway PT is in
Balance Mode.
WARNING!
To Next Page
Loading...
