Segway Pt x2 - Page 143

131
English
English
Table 14. Icons for Startup Errors
Display Icon Description Recommended
Action
The Segway PT is
plugged in.
Unplug the Power
Cord. If the Segway PT
has powered off, power
on again.
The charge in the
Segway PT Batteries is
too low to allow safe
operation of the
Segway PT.
Charge the Batteries,
and then attempt to
power on.
A Rider Detect sensor
is on at startup.(The
corresponding icon in
the display will blink).
Make sure your foot is
not on the Mat when
powering on your
Segway PT.
Check the Mat to
ensure it is clear of
foreign objects and not
sticking to the
Powerbase. If
necessary, remove and
inspect, then reinstall
the Mats (see
“Removing/Installing
the Mats” on page
109).