Segway Pt x2 - Removing the Handlebar

98
Removing the Handlebar
Tool Required: 3mm hex wrench.
To remove the Handlebar from the LeanSteer Frame:
1. Make sure the Segway PT is unplugged and powered off.
2. Using the 3mm hex wrench, remove the 3 fasteners that secure
the Handlebar Clamp to the LeanSteer Frame.
3. When you remove these fasteners and the Handlebar Clamp, the
Handlebar is released from the LeanSteer Frame (see Figure
33).
Figure 33. Remove Handlebar from the LeanSteer Frame