109
English
English
Removing/Installing the Mats
Tools Required: None.
To remove a Mat:
1. Make sure the Segway PT is unplugged and powered off.
2. Lift the Mat off the Powerbase.
To install a Mat:
1. Make sure the Segway PT is unplugged and powered off.
2. Verify that the top of the Powerbase and bottom of Mat are clean,
dry, and free of debris.
3. Place a Mat on the Powerbase. See Figure 41.
4. Fit the Mat’s rubber tabs into the Powerbase grooves.
5. Tuck the tabs in place around the entire perimeter of the Mat
while you press down.
6. Visually confirm that the Mat is properly aligned and all rubber
tabs are tucked in prior to riding.
Figure 41. Removing and Installing the Mats
To Next Page
Loading...
