23
English
English
Rider Detect Error icons If any two of the four Rider Detect Sensors
(two located beneath each Mat) are not
depressed while you are riding, the Rider
Detect Error icons will be displayed. The
Rider Detect Error icons display in Standby
Mode if you attempt to step onto a
Segway PT that is not ready to ride. Rider
Detect Error icons display at startup if there
is any weight on the Mats.
AC Power icon Indicates the Segway PT is plugged in to AC
power.
InfoKey Controller Low
Battery icon
Indicates the InfoKey Controller battery must
be replaced. Dispose of the battery properly
in accordance with regulations governing
disposal of toxic materials. CR2430
replacement batteries are available at
electronics stores. A spare InfoKey
Controller battery ships with your new
Segway PT, stored beneath the Console
Trim.
Segway PT Battery
Gauge
Indicates the amount of power remaining in
the Segway PT Batteries.
Warning icon Indicates a warning condition caused by
factors such as aggressive riding, system
operating outside of temperature range, rider
lifting foot off of Mat, etc.
Table 3. InfoKey Controller Buttons and Icons
Control Description
To Next Page
Loading...
