Segway x2 SE - Battery Installation

Segway Personal Transporter SE Service Manual
3–3
Batteries (cont.)
Installation
Tools Required: 3 mm hex wrench
Torque wrench
CAUTION!
To avoid risk of damage, do not use power tools.
1. Make sure the PT is powered off and unplugged.
2. Tip the PT onto its side so the Wheel lies flat against
a smooth, clean surface.
3. Install one of the Batteries on the Powerbase, with
the curved edge of the Battery to the outside of the
Powerbase. See Figure 3–2.
4. Ensure the Battery is aligned straight against the
Powerbase edge trim, and there are no uneven gaps.
5. Install the two center fasteners first; do not tighten.
6. Install the two outer fasteners; do not tighten.
7. Torque the center fasteners first, then the outer
fasteners to 1.6 N-m (14 in-lbf).
8. Verify the battery is aligned and straight against the
Powerbase edge trim and there are no uneven gaps.
9. Repeat Steps 1–8 for the second Battery.
10. Perform post-service tests (page A–1).
Battery
20541-00002
1.6 N-m (14 in-lbf)
Batteries
Figure 3–2: Torque the two center fasteners first.